Blue Vine (60.96 x 88.90 cm) - Redesign Décor Transfers® FLAT XL

Applying Redesign Décor Transfers is truly child's play. We explain how it works below.

STEP 1

Prepare the surface where you want to apply the transfer. Sand it smooth if necessary and ensure the surface is free of dust and grease. 

STEP 2

Determine exactly where you want the transfer and cut out specific pieces if necessary. Do not remove the protective film yet and be careful that no parts of the transfer stick to places where you don't want them to. It is difficult—virtually impossible, in fact—to remove it once it has stuck.
Especially when you are cutting out pieces of the transfer and want to stick them next to or over each other, it is useful to attach the cut-out pieces to your furniture with some painter's tape, keeping the protective film on. This gives you a good overview of your own design and allows you to keep building your "puzzle."
You can apply different pieces of the transfer over each other. In places where the designs overlap, the bottom design will no longer be visible. By letting pieces overlap partially, you create more depth in the design. 

STEP 3

Once you are satisfied with where you want each piece or the entire transfer to be, remove the pieces held by the painter's tape. Remove the protective film one by one and then apply the transfer, adhesive side down, to the desired locations. Try to do this as straight and tautly as possible so that you do not create any bubbles. 

STEP 4

Using the included stick, rub the transfer onto the piece of furniture. Place the long side of the stick upright at an angle of approximately 45 degrees against the back of the transfer. Through the rubbing and pressure of the stick, the image will gradually transfer from the film to the furniture. The principle is just like that of a temporary tattoo. 

The easiest way is to work slowly from left to right, or vice versa. Each time you have done a small section, gently pull the backing film up to see if the design has transferred properly. If not, lay the film back over the design and continue rubbing with the stick. This way, you gradually work your way to the right until the image is fully transferred. 

And you're done...!