Bouquet de Provence (21.59 x 27.94cm) - Redesign Décor Transfers® MIDDY

Applying Redesign Décor Transfers is truly child's play. We explain how it works below.

STEP 1

Prepare the surface where you want to apply the transfer. Sand it smooth if necessary and ensure the surface is free of dust and grease. 

STEP 2

Determine exactly where you want the transfer and cut out specific pieces if necessary. Do not remove the protective film yet, and be careful that no parts of the transfer stick to areas where you don't want them. Once they do, it is difficult - practically impossible, even - to remove them.
Especially when you are cutting out pieces of the transfer and want to stick them next to and over each other, it is useful to tape the cut-out pieces, with the protective film still attached, to your furniture with some painter's tape. This way, you get a good overview of your design and can continue to build your "puzzle".
You can apply different pieces of the transfer over each other. In places where the designs overlap, the bottom design will no longer be visible. When you partially overlap pieces, you create more depth in the design. 

STEP 3

Once you are satisfied with where you want each piece or the entire transfer, remove the pieces held by the painter's tape. Remove the protective film one by one and then apply the transfer, adhesive side down, to the desired locations. Try to do this as straight and taut as possible so that you do not create any bubbles. 

STEP 4

Then, use the included stick to rub the transfer onto the piece of furniture. Place the stick with the long side upright, at an angle of approximately 45 degrees on the back of the transfer. Through the rubbing and the pressure of the stick, the image will gradually transfer from the film to the furniture. The principle is just like that of a temporary tattoo. 

The easiest way is to work slowly from left to right, or vice versa. Each time you have finished a small section, gently pull the backing film upward to check if the design has transferred well. If not, lay the film back over the design and continue rubbing with the stick. This way, you gradually work your way to the right until the image is completely transferred.

And you're done...!