Branch Harmony (60.96 x 88.90 cm) - Redesign Décor Transfers® FLAT XL

Applying Redesign Décor Transfers is truly child's play. We explain how it works below.

STEP 1

Prepare the surface where you want to apply the transfer. Sand it smooth if necessary with some sandpaper and ensure the surface is dust-free and grease-free.

STEP 2

Determine exactly where you want the transfer and cut out specific pieces if necessary. Do not remove the protective backing yet and be careful that no parts of the transfer stick to places where you don't want them. Once it sticks, it is difficult—virtually impossible—to remove it.
Especially when cutting out pieces of transfer and wanting to stick them next to or over each other, it is useful to attach the cut-out pieces, with the protective backing still on, to your furniture with some painter's tape. This way, you get a good overview of your own design and can keep building your "puzzle."
You can apply different pieces of transfer over one another. In places where the designs overlap, the bottom design will no longer be visible. When you let pieces overlap partially, you create more depth in the design.

STEP 3

Once you are happy with the placement of each piece or the entire transfer, remove the pieces held with painter's tape. Remove the protective backing one by one and then apply the transfer, adhesive side down, to the desired locations. Try to do this as straight and taut as possible so that you do not create any bubbles.

STEP 4

Using the included stick, rub the transfer onto the piece of furniture. Hold the stick with the long side upright, at an angle of approximately 45 degrees against the back of the transfer. Due to the rubbing and the pressure of the stick, the image will gradually transfer from the sheet to the furniture. The principle is just like that of a temporary tattoo.

It is easiest to work slowly from left to right, or vice versa. Each time you have finished a small section, gently pull the backing sheet up to see if the design has transferred well. If not, lay the backing back over the design and continue rubbing with the stick. In this way, you gradually work your way to the right until the image has been completely transferred.

And you're done...!