Azure Blossom (60.96 x 76.2 cm) - Redesign Décor Transfers® FLAT XL

Applying Redesign Décor Transfers is truly child's play. We explain how it works below.

STEP 1

Prepare the surface where you want to apply the transfer. Sand it smooth if necessary and ensure the surface is free of dust and grease. 

STEP 2

Determine exactly where you want the transfer and cut out specific pieces if necessary. Do not remove the protective film yet and be careful that no parts of the transfer stick to places where you don't want them to. It is difficult—nearly impossible, in fact—to remove it once it has stuck.
Especially when you are cutting out pieces of the transfer and want to stick them next to or over each other, it is useful to attach the cut-out pieces, with the protective film still on, to your furniture using some painter's tape. This way, you get a good overview of your design and can continue building your "puzzle."
You can apply different pieces of the transfer over each other. In places where the designs overlap, the bottom design will no longer be visible. When you let pieces partially overlap, you create more depth in the design. 

STEP 3

Once you are satisfied with where you want each piece or the entire transfer, remove the pieces held with painter's tape. Remove the protective film one by one and then apply the transfer, adhesive side down, to the desired locations. Try to do this as straight and taut as possible so that you do not create any bubbles. 

STEP 4

Then, use the included wooden stick to rub the transfer onto the piece of furniture. Place the long edge of the stick upright at an angle of approximately 45 degrees against the back of the transfer. Through the rubbing and the pressure of the stick, the image will gradually transfer from the film to the furniture. The principle is just like that of a temporary tattoo. 

It is easiest to work slowly from left to right, or vice versa. Every time you have done a small section, gently pull the backing film upward to see if the design has transferred well. If not, lay the film back over the design and continue rubbing with the stick. In this way, you gradually work your way across until the image has been completely transferred. 

And you're done...!